| Interface | 24 Ports RJ45 Gigabit + 4 SFP Gigabit Ports |
| PoE characteristics | Up to 90W ports 1-2 and 23-24 IEEE802.3bt Hi-PoE
Up to 30W ports 3-22 IEEE802.3af/at PoE/PoE+
Maximum 360W |
| Supported Topologies | Ring / Star / Bus / Tree |
| Physical Layer Protocols | MDX/MDIX/Flow Control |
| Network Protocols | VLAN/STP/RSTP/MST/ERPS/SNMP/IGMP Snooping/802.1x/Port Isolation/QinQ |
| Management Protocols | SNMP/CLI/Console/WebUI/SSH/Telnet/Rmon |
| Quality of service | Highlighting and priority mapping
Supports SP and WRR algorithms
Rate limit
QoS-based policies |
| Link Aggregation | Up to 12 groups |
| Jumbo Frame | 10Kbyes |
| ACL | Supports 500 ACL of standard and extended type |
| Switching Capacity | 68Gbps |
| MAC Table | 16K |
| Packet Forwarding Rate | 50,59Mbps |
| Buffer | 12M |
| Installation | DIN rail |
| Power | DC 48 V ~ 58 V- The equipment does not include power supply. The following references are recommended:
- DC48V5A-DIN |
| Dimensions | 108 (D) x 104 (H) x 143 (W) mm |
| Weight | 1,3 Kg |
| Operating temperature | -40º C ~ 75º C |
| Relay Output | Switch failure is reported via relay. The relay interface can be connected to a buzzer or other monitoring devices to achieve the physical layer shutdown alarm function. When the switch is off, RELAY1 and RELAY2 will change to the connected state and, therefore, the buzzer will sound and the monitoring devices will detect the switch failure and report the errors to the data center. This output cannot be configured at software level. |
Login
